Please call For more information regarding this device
The Neuron4 is a 4 channel electroencephalogram with a low noise floor of 0.25 μV peak to peak from 0.1 to 10.0Hz, meaning you can train without worrying about hardware based noise contamination. On top of our low-noise design, the Neuron4 is a non-multiplexed, multi-channel readout amp, minimizing slew for the most accurate neurofeedback sessions.
In NeuroField64 you can use our synchronized EEG and stimulation (pEMF, tACS, or both) Z-score or amplitude training to take things to the next level, with targeted stimulation and measured response. With the added HRV monitor, you can train to heart based muscle response as well.
|Input Range||+/-100mV EEG, +/-5 VDC|
|Input Noise||0.25 μV P – P, 0.1-10.0Hz|
|Common Mode Rejection Ratio||>120dB from 0-60Hz|
|Single Pole Low Pass Filter||~80Hz|
|Resolution||24 bits (EEG & HRV)|
|Sample Rate/Data Rate||256 Samples/sec|
|Full Scale Input Range||+/-2.25 V|
|EEG Resolution||0.02 μVolts/LSB|
|EEG Channel Bandwidth||Software Controllable|
|DC Offset Measurement||Average DC Level|
|Sensor Contact Quality||Monitored Via Offset Voltage|
|PC Connection||USB – CAN Optically Isolated|
Neuron4 Package Details
The Neuron4 kit includes everything you would need to operate the Neuron4 system. The Neuron4 is a four channel electroencephalograph and heart rate variability monitor, and it does not provide any form of stimulation. If you wish to run stimulation therapies, take a look at our X3000 or Z3.
-One RRC2040 Battery Pack
-One Battery Pack Charger (100-240VAC)
-Access to NeuroField64
Please Check our Hardware Recommendations page to see if your computer will run our software.
NeuroField products and procedures have not been evaluated by the FDA. The Neuron4 is a battery powered device that is 510K exempt. All NeuroField devices are meant for stress reduction and relaxation.